Archives and Documentation Center
Digital Archives

Browsing M.S. Theses by Author "Özturan, Turan."

Browsing M.S. Theses by Author "Özturan, Turan."

Sort by: Order: Results:

  • A comparison of deep shaft sinking techniques; |a case study using the conventional method 
    Özdemir, Murat. (Thesis (M.S.) - Bogazici University. Institute for Graduate Studies in Sciences and Engineering, 1998., 1998.)
    Shaft is defined as an undeground cavity of an inclination 45 to 90 degrees to the horizontal line, of a straight course, of a minimum cross section of approximately 10m2, and of an essentially larger length in the vertical ...
  • A study on the utilization of steel slag in concrete 
    Arslan, Ehat Giray. (Thesis (M.S.)-Bogazici University. Institute for Graduate Studies in Science and Engineering, 2007., 2007.)
    Steel slag is a by-product of the steel production. The scope of this thesis is to investigate the effect of steel slags, using as replacement of Portland cement, on the physical and mechanical properties of mortars and ...
  • Effect of column aspect ratio on punching strenght of concrete flat-plates 
    Özden, Özlem. (Thesis (M.S.) - Bogazici University. Institute for Graduate Studies in Science and Engineering, 2001., 2001.)
    Traffic congestion is a serious problem seen in crowded areas like Istanbul. It does not only cause considerable time losses, but also causes waste of resources because of increase in fuel consumption and monetary cost of ...
  • Effect of curing on resistance to deicing salt scaling, freezing-thawing and chloride penetration of fly ash concrete 
    Baştopçu, Mehmet Emre. (Thesis (M.S.) - Bogazici University. Institute for Graduate Studies in Science and Engineering, 2000., 2000.)
    The four concrete mixtures used in this study contained 0%, 15%, 30%, and 40% fly ash replacing portland cement by mass. To determine the effect of curing type, three different curing conditions were used. Curing Type 1 ...
  • Effect of fiber type on mechanical properties and durability aspects of fiber reinforced concrete 
    Dimoutsis, Alexandros. (Thesis (M.S.)-Bogazici University. Institute for Graduate Studies in Science and Engineering, 2009., 2009.)
    In this study an experimental program is conducted to investigate the effects of fiber addition to concrete mixes on the mechanical properties of concrete, rebar corrosion resistance and sorptivity of concrete. For this ...
  • High volume fly ash concretes for sustainable applications in construction 
    Balcı, Elifsu. (Thesis (M.S.) - Bogazici University. Institute for Graduate Studies in Science and Engineering, 2022., 2022)
    Reducing CO2 emission has become one of the most important subjects that the world focuses. Various actions are taken to make the construction materials and methods sustainable since the construction industry has a great ...
  • Mechanical and francture properties of pumice lightweight aggregate steel fiber reinforced concrete 
    Epözdemir, Ali Can. (Thesis (M.S.) - Bogazici University. Institute for Graduate Studies in Science and Engineering, 2019., 2019.)
    Composite materials are widely used with many purposes in contemporary engineering applications. Lightweight composites are mostly used in aerospace and military engineering applications but as well as in construction ...
  • Mechanical properties of lightweight concrete made with fiber reinforced fly ash pellets 
    Yıldırım, Hasan. (Thesis (M.S.) - Bogazici University. Institute for Graduate Studies in Science and Engineering, 2012., 2012.)
    In this study, an extended experimental programme was conducted to investigate some physical and mechanical properties of lightweight concretes (LWCs) made with cold bonded fiber reinforced fly ash pellets and also tire ...
  • Risk identification and analysis of private hospital constructions in Turkey 
    Yılmaz, Esra Gülen. (Thesis (M.S.)-Bogazici University. Institute for Graduate Studies in Science and Engineering, 2010., 2010.)
    Investments of Private hospital projects in Turkey are subject to substantial risks, which may not only emerge from project activities such as design and construction, but also from global issues beyond the control of ...

Search Digital Archive


Browse

My Account